Basement laundry, long horizontal runs and two or three elbows between the dryer and daylight.
Regular routes, no travel surcharge, and a firm price before anything starts.
Get a Free QuoteHouses built in Butte before 1930 were not built with laundry rooms, so the dryer went wherever there was space - which is almost always the basement. That means a long horizontal run to reach an exterior wall, frequently with a couple of elbows and a section sagging between floor joists.
Every one of those features is a lint trap. Elbows slow the airflow and give fibre something to catch on; sags collect both lint and the condensation that forms when warm moist exhaust meets a cold basement wall. Wet lint packs far harder than dry lint, and it is what turns a slow dryer into a blocked one.
| Job | Typical price |
|---|---|
| Basement run under 15 feet | $120 - $160 |
| Long or multi-elbow basement routing | $160 - $220 |
| Added to a chimney sweep, same visit | $85 - $110 |
| Exterior hood replaced | quoted on findings |
More on how we do this work on the Dryer Vent Cleaning page, or see everything we cover in Butte.
The hood on the outside wall has a flap that is supposed to open under airflow and fall closed when the dryer stops. When lint mats it part-open, it stops being a one-way valve. Cold Butte air then moves back up the duct between loads, the residual moisture in the run condenses against it, and the whole system gets damper and packs tighter with every cycle.
Cleaning from the laundry room alone will never fix that, which is why we work the full run and finish at the outside wall with the hood off and the flap cleared. It is also why we measure airflow outside rather than inside - the number at the terminal is the one that reflects the whole system.
Call or send the form and we'll come back with a firm number, usually the same day.